Search
Now showing items 1-10 of 15
Surface repair of aircraft titanium alloy parts by cold spraying technology
(ХАІ, 2020)
Titanium alloys have the advantages of high specific strength, good corrosion resistance, high heat resistance, and low density, which is the main structural material of aerospace system components, including compressor ...
Review of manufacturing and repair of aircraft and engine parts based on cold spraying technology and additive manufacturing technology
(ХАІ, 2020)
Cold spray technology is a method of deposited metal coatings by high
speed particle impact, especially in the
preparation of metal alloy materials (Cu alloys, Ti alloys, Al alloys, Ni based alloys, Mg alloys, stainless ...
Creation of afterburning turbofan engine - history and present
(ХАІ, 2020)
The main problems of the creation of afterburning turbofan engines, among which the irremovable surge of the compressor, is disclosed by historical analysis. According to the published models, such surge is a hydrody-namic ...
Research on wear resistance coating of aircraft titanium alloy parts by cold spraying technology
(ХАІ, 2020)
Titanium alloys are the main structural material of aerospace system component, about 75 % of titanium and titanium alloys are used in the aerospace industry, which have the advantages of low density, high specific strength ...
Discharge characteristics of the magnetron system for sputtering, deposition, and nanotechnology applications
(ХАІ, 2020)
Magnetron sputtering is known for years as a powerful tool for coating deposition of cutting tools and machine parts. However the experimental measurements of the magnetron discharge parameters are still necessary to provide ...
Review of application and research based on cold spray coating materials
(ХАІ, 2021)
Cold spray technology is an advanced spray technology, and its technical principle is the same as that of additive manufacturing technology. Cold spraying technology combines multiple advantages in the spraying field: not ...
Plasma-enhanced thermal growth of copper oxide nanostructures on anode of glow discharge setup
(ХАІ, 2021)
Plasma-enhanced growth of copper oxide nanostructures is widely explored in science and manufacturing, since it provides the flexibility, productivity, and cost-effectiveness necessary to meet the growing demands of ...
The calculation of the heat control accumulator volume of two-phase heat transfer loop of a spacecraft thermal control system
(ХАІ, 2021)
The article presents the results of ground experiments, on the basis of which the verification of various models and correlations for phase slip was carried out. The applicability of the models and correlations to ...
Catalytic synthesis of graphite oxide and graphite nanostructures in transient glow-to-arc plasma discharge
(ХАІ, 2022)
Carbon and carbon-based materials like graphene and graphene oxide exhibit a constantly expanding field of applications in science, medicine, and industry. However, their implementation is still hindered by the absence of ...
Синтез планетарних механізмів типу AI з врахуванням кутів зачеплення для зв'язаних та незв'язаних коліс
(ХАІ, 2022)
Предметом вивчення в статті є процеси синтезу планетарних зубчастих механізмів типу АІ з незв'язаними та зв'язаними колесами для вирішення завдань проектування зубчастих коліс. Метою є розробка синтезу планетарних механізмів ...